content top

OSPF Configuration Overview Part 4

Welcome back to section 4 of the OSPF Configuration overview series of articles. We will continue working on the following network and pick up from where we left off. Note that I augmented the diagram by adding a couple of networks that R6 will be advertising to R1. The first thing that we will do is configure the link between R1 and R6 which will be running EIGRP. On R1 and R6 we will configure the IP addressing information on those two...

Read More

OSPF Configuration Overview Part 3

This section will pick up from where we left off in the previous article. We are configuring the following network: Area 0 should be completely configured and the other two areas should also have been configured in a similar manner. Here are the configuration commands for R3 that will also apply to R5: R3(config)#interface loopback 0 R3(config-if)#ip address 10.32.0.1 255.255.255.0 R3(config-if)#no shutdown R3(config)#interface...

Read More
content top